mywifiextd.net

Call Now

Netgear EAX14 Setup | AX1800

With the powerful Netgear EAX14 Setup, you can increase the performance of your present WiFi network by 1.5 times. With its quad-core 1.5 GHz processor, you can play games and stream 4K UHD content quickly. After setting up the Netgear EAX14 extender, you can start using 1.8 Gbps of lightning-fast WiFi.

New Extender Setup

How to Setup Netgear EAX14 Manually ?

  • Enter the Netgear EAX14’s plug into a power source.
  • Make sure your device is connected to the EAX14 using Wi-Fi or an Ethernet connection.
  • Using the default IP address, open a web browser and go to the Netgear EAX14 setup page.
  • Use the standard username and password to log in.
  • To manually configure your EAX14, including Wi-Fi network settings and security options, follow the setup guide.
  • While you wait for the EAX14 to reset, save your settings.
  • After you’ve rebooted, check that your connection is configured properly.
Netgear Eax11 Extender

Netgear EAX14 Extender Setup WPS Button

  • Enter the Netgear EAX14’s plug into a power source.
  • The WPS LED on the EAX14 will blink if you press and hold the WPS button.
  • Press the WPS button for two minutes.
  • Watch for the EAX14’s WPS LED to solidly turn white, indicating a successful connection.
  • Steps 2-4 must be repeated if the connection is lost.
  • After connecting, move the EAX14 to the best spot for more Wi-Fi coverage.
  • To make sure the extender is operating properly, test your connection.

How to Login Netgear EAX14 | AX1800 ?

  • Use an Ethernet cable for connecting your device to the EAX14 or the NETGEAR_EXT Wi-Fi connection.
  • In the address bar of an open web browser, input 192.168.1.250 or mywifiext.net login.
  • Enter the password and username that are default.
  • Tap or click Log In.
  • The Netgear EAX14 settings interface will be displayed to you.
  • As necessary, modify setups or settings.
  • Before closing the interface, save your changes.

Firmware Update Netgear EAX14 WiFi Range Extender

  • Use an Ethernet cable or the EAX14 Wi-Fi network to connect your device.
  • Start your internet browser and type 192.168.1.250 or mywifiext.net setup into the address box.
  • Enter your login information to log in.
  • Go to Maintenance or Settings, then choose Firmware Update.
  • To check for changes, click or tap it.
  • In the event that an update is available, download and install the firmware by following the on-screen directions.
  • Restarting the extender will cause the changes to take effect after the update is finished.

How to Reset Netgear EAX14 | AX1800 ?

  • Find the EAX14’s reset button.
  • Put a paperclip or other such device into the reset hole.
  • Once the power LED begins to blink, press and hold the reset button for approximately ten seconds.
  • Give the reset button a release.
  • Wait for a restart and factory default settings recovery of the EAX14.
  • Once the reset procedure is finished, adjust the EAX14’s settings as needed.